2018 Toyota Sequoia Control Arms
3 OEM control arms fit the 2018 Toyota Sequoia. Each part page lists verified Chinese manufacturers with FOB prices, MOQ and lead times — send one inquiry to collect quotes.
| OEM | Part | Fitment |
|---|---|---|
| 48069-09090 | Toyota Tundra Front Suspension Control Arm Sub-Assembly Lower Left | Lower Driver Side |
| 48068-09100 | Toyota Tundra Front Suspension Control Arm Sub-Assembly Lower Right | Passenger Side |
| 48790-0C010 | Toyota Sequoia Arm Assembly, Upper Control, Rear Left | Rear Driver Side |
More 2018 Toyota Sequoia parts
Tail Lights (8)Exterior Door Handles (5)A/C Evaporators (3)Window Regulators (4)Fuel Pumps (3)Headlights (5)A/C Hoses (11)Brake Pads (4)Wheel Bearings (3)Alternators (3)Drive Belts (4)Brake Calipers (4)Shock Absorbers (5)CV Boots (3)Brake Boosters (3)ABS Speed Sensors (6)Brake Lines (4)All Sequoia control arms →
Sourcing FAQ — 2018 Toyota Sequoia control arms
- How much do control arms for the 2018 Toyota Sequoia cost?
- Verified FOB factory quotes for 2018 Toyota Sequoia control arms on PartzealHQ currently run $6.60–$25 per unit, across 5 verified Chinese suppliers covering 3 OEM part numbers. Final pricing depends on specification, order volume and packaging — send one inquiry to collect current quotes.
- What is the minimum order quantity (MOQ) for 2018 Toyota Sequoia control arms?
- Listed MOQs for these control arms start at 1 unit per SKU. Factories often accept a smaller trial order for first-time buyers at a higher unit price.
- Will these control arms fit my 2018 Toyota Sequoia?
- Every part on this page is matched to the 2018 Toyota Sequoia by OEM fitment data. Before ordering, confirm your exact OEM number, trim and drivetrain on the part page — interchange can vary by trim, engine and build region.
- Should I buy a bare control arm or a complete assembly?
- Complete assemblies ship with the ball joint and bushings already pressed in, cutting installation labor and the risk of press damage; bare arms suit shops that reuse serviceable joints. Verify ball-joint stud taper and bushing durometer match OE, check the housing is forged or properly stamped steel, and ask for salt-spray and fatigue-test reports.