2017 Toyota RAV4 Ball Joints
3 OEM ball joints fit the 2017 Toyota RAV4. Each part page lists verified Chinese manufacturers with FOB prices, MOQ and lead times — send one inquiry to collect quotes.
| OEM | Part | Fitment |
|---|---|---|
| 43330-09720 | Lower Ball Joint Assembly Front Left | — |
| 43330-49095 | Lower Ball Joint Assembly Front Left | — |
| 43330-49215 | Lower Ball Joint Assembly | — |
More 2017 Toyota RAV4 parts
Brake Rotors (6)A/C Hoses (9)Wheel Bearings (7)Brake Pads (5)Brake Calipers (10)ABS Speed Sensors (6)Master Cylinders (5)Brake Boosters (4)Shock Absorbers (5)Control Arms (5)CV Boots (7)Sway Bar Links (4)Caliper Brackets (8)Air Filters (3)Water Pumps (4)Alternators (4)Drive Belts (4)Spark Plugs (3)CV Axles (13)Tie Rod Ends (4)Cabin Air Filters (3)Sway Bar Bushings (6)A/C Condensers (3)A/C Compressors (5)A/C Evaporators (3)Blower Motors (4)Window Regulators (8)Throttle Bodies (3)Radiator Cooling Fans (6)Fuel Pumps (4)Exterior Door Handles (10)Headlights (9)Tail Lights (15)Radiators (4)Wiper Blades (8)Mass Air Flow Sensors (4)Starter Motors (4)Car Mirrors (10)Door Locks (7)Radiator Hoses (4)Engine Mounts (6)Coolant Reservoirs (3)Fog Lights (6)Power Window Switches (4)Wiper Motors (4)All RAV4 ball joints →
Sourcing FAQ — 2017 Toyota RAV4 ball joints
- How much do ball joints for the 2017 Toyota RAV4 cost?
- Verified FOB factory quotes for 2017 Toyota RAV4 ball joints on PartzealHQ currently run $1.50–$10 per unit, across 3 verified Chinese suppliers covering 3 OEM part numbers. Final pricing depends on specification, order volume and packaging — send one inquiry to collect current quotes.
- What is the minimum order quantity (MOQ) for 2017 Toyota RAV4 ball joints?
- Listed MOQs for these ball joints start at 50 units per SKU. Factories often accept a smaller trial order for first-time buyers at a higher unit price.
- Will these ball joints fit my 2017 Toyota RAV4?
- Every part on this page is matched to the 2017 Toyota RAV4 by OEM fitment data. Before ordering, confirm your exact OEM number, trim and drivetrain on the part page — interchange can vary by trim, engine and build region.
- What should I verify on a suspension ball joint?
- Because it is a safety-critical load-bearing part, confirm a forged (not cast) housing, a hardened stud with the correct taper and tightening torque spec documented, and a low-friction polymer bearing seat. The dust boot must be ozone-resistant and tightly retained — boot failure causes nearly all premature wear. Ask for pull-out, articulation-torque and salt-spray test reports.