2015 Toyota Sequoia Control Arms
3 OEM control arms fit the 2015 Toyota Sequoia. Each part page lists verified Chinese manufacturers with FOB prices, MOQ and lead times — send one inquiry to collect quotes.
| OEM | Part | Fitment |
|---|---|---|
| 48069-09090 | Toyota Tundra Front Suspension Control Arm Sub-Assembly Lower Left | Lower Driver Side |
| 48068-09100 | Toyota Tundra Front Suspension Control Arm Sub-Assembly Lower Right | Passenger Side |
| 48790-0C010 | Toyota Sequoia Arm Assembly, Upper Control, Rear Left | Rear Driver Side |
More 2015 Toyota Sequoia parts
Tail Lights (4)Exterior Door Handles (5)Window Regulators (4)Fuel Pumps (3)Headlights (4)A/C Hoses (11)Air Filters (3)Wheel Bearings (3)Alternators (3)Drive Belts (3)Brake Calipers (8)Shock Absorbers (8)CV Boots (3)Oxygen Sensors (5)ABS Speed Sensors (3)Brake Lines (5)Wiper Blades (6)Gas Caps (4)Fuel Injectors (3)Car Mirrors (8)Door Locks (8)Radiator Hoses (3)Engine Mounts (4)Power Window Switches (4)Caliper Brackets (4)All Sequoia control arms →
Sourcing FAQ — 2015 Toyota Sequoia control arms
- How much do control arms for the 2015 Toyota Sequoia cost?
- Verified FOB factory quotes for 2015 Toyota Sequoia control arms on PartzealHQ currently run $6.60–$25 per unit, across 5 verified Chinese suppliers covering 3 OEM part numbers. Final pricing depends on specification, order volume and packaging — send one inquiry to collect current quotes.
- What is the minimum order quantity (MOQ) for 2015 Toyota Sequoia control arms?
- Listed MOQs for these control arms start at 1 unit per SKU. Factories often accept a smaller trial order for first-time buyers at a higher unit price.
- Will these control arms fit my 2015 Toyota Sequoia?
- Every part on this page is matched to the 2015 Toyota Sequoia by OEM fitment data. Before ordering, confirm your exact OEM number, trim and drivetrain on the part page — interchange can vary by trim, engine and build region.
- Should I buy a bare control arm or a complete assembly?
- Complete assemblies ship with the ball joint and bushings already pressed in, cutting installation labor and the risk of press damage; bare arms suit shops that reuse serviceable joints. Verify ball-joint stud taper and bushing durometer match OE, check the housing is forged or properly stamped steel, and ask for salt-spray and fatigue-test reports.