2020 Honda Civic Ball Joints
4 OEM ball joints fit the 2020 Honda Civic. Each part page lists Chinese manufacturers with FOB prices and MOQ — send one inquiry to collect quotes.
| OEM | Part | Fitment |
|---|---|---|
| 06510-TBA-A00 | 2020 Honda Civic Joint Kit, Front Ball (Lower) | — |
| 51220-TBA-A01 | 2020 Honda Civic Ball Joint Complete, L | — |
| 51220-TEA-T01 | 2020 Honda Civic Joint, Front Ball (Lower) | — |
| 51220-TGH-305 | 2020 Honda Civic Joint, Front-Ball | — |
More 2020 Honda Civic parts
Brake Pads (8)Engine Coolant Thermostats (3)Caliper Brackets (3)Brake Calipers (20)Master Cylinders (6)Wheel Bearings (7)Brake Rotors (9)Brake Boosters (5)CV Boots (20)Alternators (8)Spark Plugs (4)Radiators (3)Control Arms (20)Water Pumps (3)Shock Absorbers (20)Air Filters (3)Power Window Switches (8)CV Axles (24)Oxygen Sensors (7)ABS Speed Sensors (6)Fuel Pumps (12)Radiator Hoses (4)Exterior Door Handles (18)A/C Condensers (4)Window Regulators (12)Starter Motors (7)A/C Compressors (3)All Civic ball joints →
Sourcing FAQ — 2020 Honda Civic ball joints
- How much do ball joints for the 2020 Honda Civic cost?
- Verified FOB factory quotes for 2020 Honda Civic ball joints on PartzealHQ currently run $1.50–$10 per unit, across 1 verified Chinese supplier covering 4 OEM part numbers. Final pricing depends on specification, order volume and packaging — send one inquiry to collect current quotes.
- What is the minimum order quantity (MOQ) for 2020 Honda Civic ball joints?
- Listed MOQs for these ball joints start at 50 units per SKU. Factories often accept a smaller trial order for first-time buyers at a higher unit price.
- Will these ball joints fit my 2020 Honda Civic?
- Every part on this page is matched to the 2020 Honda Civic by OEM fitment data. Before ordering, confirm your exact OEM number, trim and drivetrain on the part page — interchange can vary by trim, engine and build region.
- What should I verify on a suspension ball joint?
- Because it is a safety-critical load-bearing part, confirm a forged (not cast) housing, a hardened stud with the correct taper and tightening torque spec documented, and a low-friction polymer bearing seat. The dust boot must be ozone-resistant and tightly retained — boot failure causes nearly all premature wear. Ask for pull-out, articulation-torque and salt-spray test reports.